This allows one cable to both power the unit and also carry network traffic. The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the NanoStation, and the other into the PoE Injector (which is plugged into AC power) For best performance the unit should be roof mounted, high and clear of obstructions, via it's integrated pole mounting bracket Signal strength indicators allow for quick and easy alignment. This unit has all networking hardware integrated and is completely weatherproof for permanent installation in even the toughest environments You can learn how to set up the NanoStation as a long range WiFi access point by following our Guide to extend WiFi coverage using an Ubiquiti NanoStation With a wide directional broadcast angle the NanoStation LOCO is ideal for covering sports grounds and outdoor areas by a sector-by-sector approach Login to the AirOS management software and set to AP mode to create a high performance WiFi network Management of the Ubquiti device couldn't be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface. This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work To install, place the units at either end of the network and connect both to Ethernet cables - for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other locationįace both units so they point towards each other and the link is established. There are some features, such as Dual-Ethernet capabilities, that the LOCO version doesn't have, so if in doubt, please read through the specification sheet at the bottom of the page.įorget Ethernet cable, the Ubiquiti NanoStation LOCO is ideal for bridging networks or sharing broadband between buildings If you've checked out the Ubiquiti NanoStation, the more cost effective LOCO version is simply a lower power unit designed for shorter distances Includes POE injector and 240V AC adaptor Integrated AirOS web software for controlling power, bridge/AP mode, etc. Up to 200mW output power, 2x2 MIMO operation, 100Mbps Share Internet connection between buildings, remote sites, etc. Ubiquiti NanoStation M2 LOCO (2.4GHz) Point-to-Point Wireless & WiFi APĬonnect two remote locations on the one network
0 kommentar(er)
